Oscilloscope Probes

The PICO-TA499 PicoBNC+™ 10:1 Scope Probe and Adaptor has a fixed x10 attenuation and is intended for both high-speed signals like CAN and FlexRay as well as for higher voltage signals, such as primary ignition. It is the equivalent of the existing PICO-TA375 Oscilloscope Probe and the PICO-TA197 10:1 Attenuator.

The length of the earth lead has been increased on the PICO-TA499 and is also supplied with an adaptor tip allowing it to be used with any of the 4mm Clips. The Probe is automatically recognised by PicoScope software when it is connected to the scope.

100MHz Oscilloscope Probe

These 100MHz high-quality, general purpose oscilloscope probes have sufficient bandwidth to examine high speed signals such as the control and communication busses in modern vehicles. A two-position slide switch allows attenuation of either x1 or x10 to be selected.

They are supplied with a range of accessories such as a clip used to attach the probe to the wire you are probing, a ground clip, a screwdriver used to adjust probe compensation and coloured identifiers.

This probe is particularly useful if you want to probe CAN bus and FlexRay signals.

Documentation

The PICO-TA057 active differential oscilloscope probe lets you use a standard earthed oscilloscope to measure signals that are not referenced to ground.

Documentation