Pico's Noise, Vibration and Harshness (NVH) products enable the identification
and diagnosis of unwanted vibration and noise sources in in a vehicle.
A comprehensive NVH Training Course is now
available in South Africa.
Please Note: visit VAS NVH, if you are affiliated to VW Audi.
Product Update - PicoBNC+ 4425A PicoScope
All NVH Essentials Kits have now been released with the PicoBNC+ 4425A PicoScope.
The contents of the 'A' model Kits are the same as the previous 4425 Essentials Kits,
except that the PicoScope has been upgraded.
The new Kits are slightly more expensive but are recommended as the PicoScope
can be used with all the new PicoBNC+ accessories, as well as all
the standard BNC accessories, should you wish to upgrade in future.
Tyre Vibration VW Golf 2004
A MK5 VW Golf 2.0 TDI with a distinct vibration throughout the cabin at a very specific road speed range of 67- 73 mph, presented
a real nuisance at cruising speed. This problem resulted in the customer driving at 65 or 75 mph to avoid the vibration
NVH Cabin Vibration Maserati Quattroporte 2010
The trouble with vibrations is that we all interpret them differently (which is why we should measure
and not guess), but with this vehicle you could not deny a considerable vibration throughout the
vehicle in a very specific engine speed range. Starting at 1450 rpm through to 1700 rpm the
vibration was evident, with peak vibration occurring around 1600 rpm.
Finding faulty engine mountings Rover 100 1996
My 1996 Rover 100 helped me get to grips with NVH. The first test I did was in the passenger compartment with the
accelerometer on the inner seat rail. I was a bit surprised by the magnitude of the engine second-order (E2) peak,
but, with no experience to fall back on, I asked Steve Smith at Pico for advice.
NVH diagnosis of transmission screech Opel Kadett 1991
The vehicle had developed a very loud screeching noise, which sounded like a cross between
a squealing drive belt and a loose stack of rapidly vibrating metallic plates. The car
was powered by the original GM 16SV OHC transverse-mounted petrol engine and the THM125
automatic transmission and had covered a genuine 52k miles from new.
The PicoDiagnostics NVH Kits from Pico Technology are the cost-effective answer to the many NVH problems
facing technicians today. The software provides a real-time diagnosis to the technician, in the form of
either: a bar graph, a frequency chart, a 3D frequency chart, RPM order, road speed view or a time domain view.
The ability to start the recording before a road test and playback and analyze the recording back in the shop,
ensures that the driver's attention remains on the road. Saving the recordings couldn’t be easier: Much like
our other automotive software, you can simply save the file to your laptop’s hard drive.
The PicoDiagnostics NVH kits make use of the PicoScope Automotive oscilloscopes and are available in
a number of configurations to suit your needs. You can be sure that your investment in the PicoDiagnostics
NVH kit will benefit your business without the need for further spending. If you already have a PicoScope
Automotive oscilloscope, you’re halfway there.
If you don’t have a PicoScope Automotive oscilloscope, but you wish to use an NVH kit,
you can invest in one of our Essentials kits and receive your choice of NVH Diagnostics kit
complete with a 4 channel Automotive oscilloscope in a dedicated hard carry case.
Although the NVH Kits are available in different configurations, they differ only in the number
of parts supplied. In each case, a BNC cable connects the interface box to your Automotive
PicoScope and a USB cable connects your PicoScope to the PC or laptop on which you run
the PicoDiagnostics software.
(not supplied) can be used to provide RPM data or an electrical signal that can be used for RPM.
Starter, Standard or Advanced
The Starter NVH Kit will allow you to measure vibrations on 3 axes, (X, Y and Z).
The Standard NVH Kit gives you the option to also measure vibration or sound on a single axis
at an additional location on the vehicle. The Advanced Kit gives you the option to measure
vibration or sound at four different locations on the vehicle. The Starter to Standard
Upgrade Kit gives you an extra set of all the kit items.
All Kits are available in a carry case or foam tray. The foam trays enable users
to store their NVH Diagnostics Kits safely in a tool chest of their own choosing.
Starter to Standard Upgrade
Upgrade to Essentials
Please note that the NVH Starter Kits (PICO-PQ126/8) do not contain the yellow cable PICO-TA245.
NVH Essentials Kits
If you want to use a Pico NVH Kit but do not own a PicoScope already, you can now purchase an
NVH Essentials Kit. These are the equivalent to the basic NVH Kits but with a
4-channel Automotive PicoScope 4425 included.
Customer complaints surrounding noise/vibration are subjective at best and present
technicians with a challenge before diagnosis and rectification begins. Applying
the NVH kit to the vehicle will allow the technician to road-test the vehicle
with the customer to obtain all vibration and noise levels.
Once this valuable data has been collected it can be analyzed and compared
to previous captures or against donor vehicles. Often what is perceived by
the customer to be a “problem” vibration is in fact a characteristic
Now you can present and compare objective data with test results from d
onor vehicles to reassure your customer all is OK. Alternatively,
comparing data may highlight a problem within the vehicle allowing
the technician to proceed to a repair with confidence supported b
y measurements taken.
Below are just a few of the typical scenarios where the NVH kit can save time and money:
- Cabin vibrations at speed
- Engine vibrations throughout the entire RPM range
- Clutch judder or vibration
- Transmission and bearing whine
- Auxiliary drive noise
- Brake judder
- Steering vibrations
The root of all NVH problems is a vibration. In some cases these are unwanted or
unexpected vibrations, and in other cases they are always present (e.g. engine combustion),
but should not be transmitted to the driver/passenger.
Sound is simply a vibration that is transmitted through the air (or other medium),
and is heard when it reaches a person's ear. Although the perfect hearing range is
20 Hz to 20 kHz, most of us are more like 100 Hz to 15 kHz at best. Vibrations are
usually felt at frequencies below 200 Hz, and in the overlapping frequency range
vibrations can be both felt and heard.
In order to deal with this frequency range effectively, the PicoDiagnostics
NVH kit contains both microphones (for sound), and accelerometers (for vibrations).
Traditionally, NVH problems have been viewed as difficult to solve.
NVH complaints can be subjective as people have different levels of NVH
acceptance or feeling. For a technician to tackle these issues effectively
they need the right tools and procedures to diagnose complaints in an
objective, repeatable and easy manner. The PicoDiagnostics NVH kit does
that and also generates customer reports to show that an improvement
has been made against their complaint.
Setup Wizard and Software Help
The Pico NVH test has a set of wizards to guide you through the necessary
connections and the vehicle data that will generate information and results
in a format that is easy to understand.
The system detects vibrations (and sounds) that change (wheel, engine, propshaft etc.)
but also fixed frequency vibrations (e.g. electric cooling fan). Results are displayed
in a report that is easy to understand and can be viewed in the way that suits you.
Comprehensive help files explain likely causes and solutions, and the functions
provided by the software make it easy to diagnose the problems in a logical way
to reveal the root cause. The same system will also give you the ability to
measure the effectiveness of any repairs or modifications and demonstrate
the results to the customer.
Mongoose Pro ISO/CAN J2534 Lead (PICO-TA293)
Having used the Mongoose Pro alongside Pico products for some time,
we are confident it is the best and most reliable product to use with
our NVH Kit for the acquisition of a road speed signal.
Optical Balancing Kit (PICO-PP991)
The purchase of our Optical Balancing Kit allows on-vehicle balancing in order to rectify
first order shaft vibrations. Included as part of our PicoDiagnostics software, the
Propshaft Balancing Test provides clear advice and guides you through
analysis and test procedures:
- Support for pinion flange, single weight, and hose clamp balancing weights
- Step-by-step procedures with help and graphical displays